Make sure the turnpiece is in the vertical position.
Qwickset push button door lock blicks red and doesnt work.
Press the button once more.
If it is not pull the spindle out and rotate 180 degrees.
View button locations for your lock model.
Press the lock button on the keypad then enter the security code to resynchronize the bolt.
Press the latch bolt.
Hold button until the latch bolt starts moving on its own.
Here are the instructions for the door handing.
If this doesn t work you need to remove the knob again.
Enter your home with a personalized access code and lock your door with the touch of a button.
The spindle is spring loaded and will retract back when released.
Step 3 pull out the battery pack and push program three times if the smartcode fails to initialize after battery removal and re installation.
Inspect the inside for signs of rust.
When a user attempts to enter a pin code when the lock is in lock out mode the status indicator flashes red and blue.
The door handing process was not executed during installation.
Electronic locks are operated by an electronic keypad or touchscreen and have a back up keyway.
Press and hold the a or program button while reinserting the battery pack.
Reinstall the door knob and test.
Press and hold the lock button while installing battery pack.
The keypad flashes at the same time.
Spray the locking mechanism with liquid graphite to lubricate.
All code lock out mode is a feature in which the lock rejects all user codes.
On my smartcode 909 910 the lock beeps the keypad flashes red and the door cannot lock.