Tape a one foot by one foot square of plastic sheeting plastic kitchen wrap will do to the concrete wall in your basement with duct tape and leave it in place for 24 hours.
Putting up walls in a concrete basement.
If you are finishing a basement then chances.
Basement walls of cinder block brick or even poured concrete can be transformed pretty quickly and simply with a coat of paint.
He spaces fasteners every 6 ft.
First put construction adhesive on the floor then tip the wall into place and fasten with concrete nails or screws.
And within 6 in.
And within 6 in.
Plumb and screw the studs to the blocking for a solid wall.
Steps to finishing a basement.
Make sure you have enough room to tip.
Phil fastens his walls to the floor with construction adhesive and a powder actuated tool pat.
Enjoy the videos and music you love upload original content and share it all with friends family and the world on youtube.
Again place each stud 16 inches from centre and secure the top and bottom plate.
That is if the studs are going to touch the concrete wall.
Tip the knee walls up and fasten them to the floor.
Position a top plate of 2x4 inch wood the length of your intended wall perpendicular to the floor joists of the room above.
Be sure to sight along its entire length to make sure it s straight.
Then fasten blocks through the foam into the masonry at every third stud with 3 in.
Install the knee wall.
Use string to form a plumb line and ensure that the bottom plate is perfectly lined up with the top one.
Make sure that all the curves are.
Then remove the tape.
So there is enough gap for air to flow.
Or you can leave a 4 inch gap between the studs and concrete wall and probably get away with it.
Most jurisdictions require a 4 mil plastic sheet vapor barrier for basement walls against concrete.
Install a parallel piece of 2x4 inch lumber on the concrete floor and hold it in place with adhesive and concrete nails.